Table of Contents
Does TekSavvy use IPv6?
Teksavvy now has a beta of IPv6 service over DSL. It seems to work reasonably well. As of today, it appears the IPv6 transit is provided by Hurricane Electric.
What network does TekSavvy use?
TekSavvy’s cable Internet offerings rely on Rogers, Shaw, Videotron or Cogeco infrastructure to connect customers to TekSavvy Internet. In areas served by Rogers, TekSavvy cable Internet is offered with either 15, 30 or 100 Mbit/s download speeds with the choice of 150GB, 400 GB or unlimited downloads.
How do I access my TekSavvy router settings?
Type http://192.168.1.1/admin into the address bar and then press Enter on your keyboard. If you haven’t changed the admin username and password of your router from their default values, enter admin into both the username and password fields.
How do I use IPv6 instead of IPv4?
Select IPv6 from the list of options on the left so that it is highlighted. To enable IPv6, the switch icon in the upper right corner needs to be set to ON and the Addresses pop-up underneath set to Automatic. To disable IPv6, slide the IPv6 setting to OFF. Click Apply.
Should I enable IPv6 at home?
However, the main question is: do you need IPv6 in your home network? The answer is largely, no. Only a small fraction of your devices fully support IPv6 or is able to operate in an IPv6-only network.
What is SmartRG?
It combines a full-rate ADSL modem with a wireless access point using the latest 802.11n WiFi technology. It can be used as an Ethernet or DSL gateway, and includes a router, firewall, and TR-069 management. The SR360n is designed with ease of deployment in mind.
How do I setup my SmartRG modem?
Connect Your Modem
- Connect the power supply to the modem and plug it in.
- Connect the phone cord to the modem and plug into the phone wall jack.
- Connect the network cable to the modem and then into the Ethernet port on your computer.
- Turn the power on and wait for approximately one minute.
How do I enable IPv6 routing on my router?
Enable IPv6 routing on a Cisco router using the ipv6 unicast-routing global configuration command. This command globally enables IPv6 and must be the first command executed on the router. Configure the IPv6 global unicast address on an interface using the ipv6 address address/prefix-length [eui-64] command.
How do I get an IPv6 address?
For Android users
- Go to your Android device System Settings and tap on Network & Internet.
- Tap on Mobile network.
- Tap on Advanced.
- Tap on Access Point Names.
- Tap on the APN you are currently using.
- Tap on APN Protocol.
- Tap on IPv6.
- Save the changes.