What is the hole that the door latch goes into?
The latch bore, also known as the edge bore, is the hole drilled from the side of the door into the cross bore to allow the latch of the lock to be installed and to accommodate the sliding of the deadbolt.
How do you chisel a door latch plate?
Position the strike plate on the jamb so it is centered on both lines. Score around the plate with a sharp utility knife. Using a sharp 1-inch-wide chisel, cut a series of parallel lines into the jamb about 1/4 inch apart, staying within the scored lines and holding the chisel perpendicular to the wood.
Why do door latches have two parts?
To keep the latch bolt from being push-retractable once the door is closed, a second mechanism is incorporated into the latching mechanism—called a deadlocking plunger (the entire mechanism sometimes called a deadlock latch), as shown in Figure 3.
What does mortise mean on a door?
Mortise Latch A mortise refers to the pocket cut into the door where the lock is fitted. Therefore, a mortise lockset cannot be installed on just any door. They are great for replacing the hardware on homes built before 1950.
What is a strike plate on a door?
Strike Plate This is the plate the latch-tongue, or deadbolt-tongue will connect with. It should sit flush with the door jamb. Any passage or privacy set needs to have a strike plate for the door to latch. Additionally, deadbolts need a strike plate to properly lock.
What is the purpose of a strike plate?
A strike plate or “Strike” is a metal plate that is secured to the door jamb for the purpose of reinforcing the latch on the lockset or deadbolt. They come in many different shapes and sizes, for various applications.
How do you install a door handle?
Installing a door handle is a relatively easy home project that you can do with a pre-made kit. Put your tape measure on the floor in front of your door and measure up 41 inches from the floor since this is the most common placement for door handles.
How to properly install door knobs and levers?
To install a door knob, start by removing the old door knob, latch, and strike plate, if necessary. Next, place the new latch plate on top of the latch, slide the latch inside the edge of the door, and secure the latch with 2 screws. Then, insert the first half of the doorknob and place the peg through the latch mechanism.
How to install a standard door knob?
The long metal piece sticking out of the exterior knob is called the spindle.
How to install a door lock set?
Install both knobs by sliding the spindle through the slot in the latch. Align the two long screws from the inside knob into the cylinders on the exterior door knob and tighten the screws. Remove the two screws holding the strike plate in place on the door jamb and install the new one in the same position.