How do I reset my Cisco 2960 username and password?

How do I reset my Cisco 2960 username and password?

To reset your Cisco 2960 password, connect your console cable to the switch and open up your terminal emulator software, you can use minicom if you are using Linux. Power on the switch while holding the mode button. Release the mode button after you see the screen below in your terminal emulator software.

How do I reset my Cisco 2960 console password?

Find the below steps to recovery password for Cisco 2960.

1. Power off the switch first, then press and hold the mode button while you power on the switch again.
2. To initialize the flash file system, run the command:
3. You can now list the contents of your flash by running.
4. To further boot the switch run the boot command as:

How do I reset a Cisco 2960 switch?

Reset a Cisco 2960 Switch to Factory Default Settings

1. – Start by connecting your cisco switch via a console cable that will be also connected to the same console.
2. Step 2.- Use the following commands: Router: en. Router#erase startup-config. Router# del flash:vlan.dat.
3. – Reload your cisco switch to complete the restoration.

What is the default password of Cisco switch 2960?

cisco
When prompted, enter the default password, cisco.

How do I reset my 2960x?

Reset a Cisco 2960 Switch To Factory Default Settings

1. Connect up a console cable and power on the switch, whilst holding down the “mode” button:
2. Run the following command to initialize the flash file system:
3. Delete the config.text file from the flash directory:

How do I factory Reset my switch?

Complete These Steps:

1. Select “System Settings” from the HOME Menu.
2. Scroll down to “System” and select it.
3. Scroll all the way down to the bottom of the menu and select “Formatting Options”.
4. Select “Restore Factory Settings” to delete all data in the system memory.