What does a blinking red light mean on a Trane XR80 furnace?
Trane XR80 Troubleshooting Slowly flashing shows your furnace is on and does not need heat. When it is flashing fast there is heat throughout your home. A continuous green light means the IFC circuit board needs replacing. Meanwhile a continuous off means the furnace is either off or not receiving any electrical power.
Where is the reset button on a Trane XR80?
We have researched Trane furnaces, and in this post, we will answer these questions for you. Here’s how to reset the following Trane furnace models: Trane XE80, XR80, and XR90: These furnace models typically have the reset button housed near the burner.
How do I reset my Trane XR air conditioner?
Steps In Resetting Your Trane AC Thermostat
- Switch off the thermostat.
- Locate the circuit breaker.
- Turn off the air conditioner from the circuit breaker.
- Remove the Trane thermostat from the wall.
- Wait for a few seconds.
- Switch the air conditioner and the thermostat back on.
What does 3 blinks mean on a furnace?
Have you ever looked at your furnace and thought what do 3 flashes on American Standard furnace mean? This error occurs when the combustion air pressure switch that monitors the flow of air through the vent system fails to close while the induced draft motor is operating.
Does Trane XR80 have a reset button?
What does it mean when your furnace is blinking?
Gas, Ignition Failure, or Proving Fault This could be an indicator your flame sensor is dirty, and cleaning it should fix it. However, this could also mean there is a problem with the gas valve or ignitors. Gas can be intimidating to mess with, so it’s best to call Doc Dancer.
What is a Trane XR80?
Trane’s XR80 is a single stage gas furnace with an AFUE of up to 80%. The XR80 furnace includes a four-speed blower motor, a self-diagnostic microelectronic controller, and a silicon nitride igniter. The one-piece heat exchanger offers easy installation.
How do I know if my Trane XR80 is bad?
You should count how many times the Trane xr80 blinking red light and match them with the error code below. The flashes range from two flashes to eight. These are some common Trane furnace error codes. Another problem you are likely to face with your Trane xr80 furnace is lacking power to the thermostat.
What do the error codes on a Trane furnace mean?
This is why Trane included several error codes to assist you find a specified issue. Trane provides a quick diagnostic check in their furnace with a flashing light system which is either red or green. Trane uses a red and green light flashing system to notify you when there is a specific problems that need attention.
What does the slow flashing light mean on a Trane furnace?
This code is the exact opposite of the slow flashing light code, and means that your Trane furnace is turned on and that it is presently calling for heat. This code usually means a problem only when the furnace is constantly calling for heat and not responding to your thermostat’s signals.