How do I load option on iDirect modem?
For example, if the modem is 192.168. 10.15, you would set the PC to 192.168….How to Load an Option File to an iDirect Modem.
| 1. Start Command prompt | Start/Run cmd | On your PC go to START/ RUN and type in cmd and or type cmd into the search box. |
|---|---|---|
| 6. Beamselector list | >beamselector list | Type beamselector list and |
How do I use iSite?
To launch Web iSite perform the following:
- Connect the LAN port of the PC to the LAN port of the Satellite Router using an Ethernet cable.
- Launch the Web browser of choice.
- Enter a User name and Password when the Login page displays. On the initial login, enter the default name of admin and the password of iDirect.
How do I reset my iDirect x5 modem?
If no access to the modem via console using default credentials, you will need to do a hard reset the modem.
- Press the red button at the back of the modem for 15 seconds you will see:
- Type the command: fis load linux.
- Type the command: passwd.
- Type in a password of your choice (password will not be saved after reboot)
How do I set up an iDirect modem on Linux?
First and foremost, the iDirect modems use a linux command line. If you are not familiar with linux, here are a couple of basics: The “ifconfig” command is the linux version of Window’s “ipconfig” command.
How do I configure the iDirect port for my uplogix appliance?
Use a workstation to open a command line session with the Uplogix appliance. Issue the port command to switch to navigate to the port your iDirect modem is connected to. In the example below the iDirect modem is attached to port 2. Use the config init command to configure the port for iDirect.
How do I use iDirect to find Satellite Information?
iDirect calls the service that runs all of the satellite functions on your remote, the falcon service. To get into the falcon service, type “telnet 0” from the linux command line. From there you can run a series of commands to find the satellite information you are used to looking for.
What is the use of iDirect?
iDirect calls the service that runs all of the satellite functions on your remote, the falcon service. To get into the falcon service, type “telnet 0” from the linux command line.