What is meant by F7P6 EM12K?
As an example, the classifica- tion F7P6-EM12K certifies that the product is a submerged arc flux (F); will provide weld metal of 70,000 to 95,000 psi tensile strength, a minimum of 58,000 psi yield strength and a mini- mum of 22% elongation in two inches after the weldment has been subjected to a postweld heat …
What is filler metal classification?
A filler metal classification provides details about a product’s characteristics and usability, including the type of filler metal, allowable welding positions, tensile strength, shielding gas (if needed), and chemistry/composition.
Is filler metal same as electrode?
The electrode serves as the filler metal and melts along with the metals to be welded together. For example, in typical electric arc welding, the consumable electrode is the filler metal welding rod and contains a flux that contributes to producing a barrier to protect the weld from any contamination.
What type of electrode is used in SAW?
SAW strip-cladding utilizes a flat strip electrode (e.g. 60 mm wide x 0.5 mm thick). DC or AC power can be used, and combinations of DC and AC are common on multiple electrode systems.
What are the two types of filler metal?
Four types of filler metals exist—covered electrodes, bare electrode wire or rod, tubular electrode wire, and welding fluxes. Sometimes non-consumable electrodes are included as well, but since these metals are not consumed by the welding process, they are normally excluded.
What is matching filler metal?
“Matching” filler metal is shown as both E60 and E70 electrode and flux/electrode classifications. A36 and A570 Gr. 50 have different minimum specified yield and tensile strengths, as do E60 and E70 filler metals. Obviously, matching cannot be as sim- ple as “matching” the base metal strength (see Table 1).
What does 2F mean in welding?
Horizontal Position (2F or 2G) For a fillet weld – welding is performed on the upper side of an approximately horizontal surface and against an approximately vertical surface. For a groove weld – the face of the weld lies in an approximately vertical plane.
What is ASME f-number for filler metals?
What is ASME F-Number for filler metals? F- Numbers are given based on the usability characteristics (defined in ASME Section IIC, SFA 5.1 for example for carbon steel SMAW electrodes) and metallurgy of the welding filler metal in ASME Section IX and AWS D1.1.
What factors should be considered when selecting filler metals?
Many factors must be taken into consideration when a filler metal is selected for a specific application. These factors include, but are not limited to, the type of steel, type of weld, loading on the welded joint, applicable codes, level of preheat, level of restraint, position of welding, condition of the steel, and service conditions.
What filler metal combinations can be used for single pass welds?
For single pass welds, multipass welds which are not exposed, and multipass welds which do not require resistance to atmospheric corrosion and matching weathering characteristics, other filler metal combinations may be used. (26) 880, 880M/LAC B2 may be used in place of the listed Flux/Wire combinations for most applications.
Which filler metals are used in place of the listed flux/wire combinations?
(26) 880, 880M/LAC B2 may be used in place of the listed Flux/Wire combinations for most applications. (31) Filler metals suitable for undermatching strength applications use A709, Grades 70W and HPS 70W and A852 are: MIL 800-HPNi/ LA-75, 860/LA-75 and 960/LA-75.