How do I mount my ETR 407 transponder?
Inside the vehicle, the transponder is to be mounted in the centre of the windshield behind the rear-view mirror, 5–10 cm from the top of your windshield. If the front windshield is divided in the centre by a vertical metal strip, mount the transponder at least 5 cm to the right of the strip.
Where is the transponder supposed to be mounted?
Locate the correct position for the tag — the upper center portion of your windshield behind the rearview mirror, at least 1 inch to the right of the mirror and at least 1 inch below the top edge of the windshield.
How much does it cost to replace a 407 transponder?
A Transponder Replacement Fee of $50.00 for replacing a transponder in the event that it is misused, abused, lost or stolen, or the transponder is not returned to us.
Can I move my 407 transponder in another car?
407 ETR customers who share transponders between vehicles will be responsible for any charges, including Camera Charges, that can result from moving around the transponder. Additional transponders save you the hassle and expense of entering the highway without the transponder.
Can I put my transponder on my dashboard?
Placing the transponder on the sun visor, the rear view mirror, the dashboard, the seat, or in your hand may work sometimes, but will not work all of the time. Installing the transponder incorrectly or not at all may cause unnecessary toll evasion violations, administrative fees or delays at the tollbooth.
How do you stick a transponder to a windshield?
Placing the Sticker Place the sticker transponder in the lower left-hand corner or lower right-hand corner of the inside of the windshield. Or, place it behind the rearview mirror on the inside of the windshield (Consider visual aesthetics from inside and outside of the vehicle when choosing the location.) Important!
Do 407 transponders have batteries?
The transponder is a sealed device and does not have a removable battery. When having a vehicle towed, it is advisable for drivers to let the tow truck driver know whether or not they would like 407 ETR to be used.
Can I use my 407 transponder in a rental car?
We understand you may want to take the transponder into a rented vehicle. However, as with any sharing of transponders between vehicles, you are responsible for the charges that appear on your 407 ETR bill.
Does transponder have to be on windshield?
The windshield placement is necessary so that the overhead readers can scan the transponder. There are two approved transponder locations that maximize device readability.
Does it matter where you put I-PASS?
LICENSE PLATE TAGS For vehicles with vertical windshields, such as Jeeps, buses, or trucks, I-PASS transponders must be mounted in the center of the windshield, about one to two inches from the bottom of the window. Otherwise, it may be difficult for the Tollway’s I-PASS equipment to “read” the transponder’s signal.
Where do you put the e tag on a windscreen?
It must be at least 10cm from the top of the windscreen and should be placed below any tinting or external visor. be covered with dots or be lighter than the rest of the windscreen. In this case, the tag mounting position must be within the dotted or lighter area.
How much does Bestpass cost?
$7 to $10 a month per truck
There will be a single installation and single report for each truck in a fleet. Bestpass Complete will cost owner-operators $7 to $10 a month per truck, but that cost will be more than covered by 20 percent volume discounts obtained by Bestpass and passed on to its smaller customers.
Why is my transponder not working?
There can be a few reasons why your transponder isn’t working properly, such as: You ran out of funds in your account. Your transponder’s battery is running low. Your transponder is improperly mounted.