How do I set the temperature on my Skytech remote?
Press the • MODE key until the LCD screen shows the word “ROOM.” (See Thermo Mode graphic) To adjust set temperature, press and hold the • SET key until the de- sired temperature is reached. The temperature range is 99ºF (32ºC) to 45ºF (6ºC).
What does thermo off mean?
ON indicates the system is on, either manually or thermostatically. OFF indicates the entire system is turned off. THERMO indicates the system will automatically cycle ON/OFF, depending on programmed SET temperature. PROGRAM – Indicates the system is operating with PROGRAMMED settings.
Why does my Skytech Remote not work?
Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully charged. Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery.
Why does my remote control not work?
Make sure none of the remote buttons are jammed. Reset the remote. The remote may not work temporarily due to poor contact of the battery or static electricity. Remove the batteries from the remote (for approximately 1 minute).
Why are some buttons on my remote not working?
The best way to clean circuit board and the rubber buttons is cotton + alcohol. Never use water. After cleaning both the circuit board and rubber buttons you should check if the buttons are working before proceeding. The reason is; cleaning the circuit board and rubber buttons most of the time solve the issue.
How to troubleshoot a Skytech fireplace remote?
How to Troubleshoot a Skytech Fireplace Remote. 1 1. Locate the Receiver Box. Most often your receiver box will be located within the controls cavity of your fireplace, like it is here – check to make 2 2. Replace the Batteries. 3 3. Perform the Learn Function. 4 3. Continued. 5 4. Reset the Memory.
Why is my fireplace remote not working?
If you encounter problems with your fireplace system, the problem may be with either the fireplace itself or with the remote. Review the fireplace manufacturer’s operation manual to make sure all connections are properly made. Then check the operation of the remote in the following manner:
What do I do if my Remote doesn’t work?
If you perform steps one through three and you still can’t get your remote to work, you may need to reset the memory on the receiver box. Each receiver box has a small internal memory to store the signals from the remote control, and it’s possible for this memory to fill up and not allow the learn function to work properly.