Why does my Sony Blu Ray remote not work?
Remove the batteries from the remote control and press any of the buttons on the keypad to discharge any stored current. If possible, test the batteries to make sure both have sufficient charge or replace the batteries with new ones. Reinsert the batteries properly in the remote control.
Why my Sony remote is not working?
If your Sony TV remote isn’t working, remove the batteries and wait for one full minute. Now, place the batteries back in the remote and try again. If that doesn’t work replace the batteries with new ones and make sure that there are no obstacles blocking your TV’s remote receiver.
Why is my remote control not working properly?
Clean the remote control terminals. The remote control battery terminals may be dirty. Remove the batteries and clean the remote control terminals with a small solution of alcohol, using a cotton bud or soft cloth, then place the batteries back into the remote control. Replace with fresh batteries.
How do I reset my Sony Blu-ray player remote?
Factory Reset on a Blu-ray Disc Player
- On the supplied remote control, press the HOME button.
- Select Setup.
- Select Resetting or. icon.
- Select Reset to Factory Defaults Settings.
- Select All Settings.
- Select Start.
- Select Close.
- Turn off your device, then turn it back on.
How do I pair my Sony remote?
How to pair a remote control with Sony’s Android TV via Bluetooth
- Press the [HOME] button, select [Settings]
- Select [Voice Remote Control] and press the [Activate button]
- Prepare Voice Remote Control.
- Press and hold down VOL- button.
- Press and hold the [Activate button] for 3 seconds while holding down VOL- button.
Why is my Sony remote not changing channels?
If the TV does not change channels using the remote control but does using the channel buttons on the TV, then the remote control may be in the wrong mode. Press the TV FUNCTION button on the remote control prior to changing channels.
How do I program my Sony remote?
Sony Universal Remote programming instructions.
- Turn on the component to be programmed.
- On the remote control, press and hold the SET button until the SET indicator lights up.
- Press the appropriate component select button for the component being set up.
- Using the number pad, enter the component’s manufacturer code.