Why does my Maytag Neptune dryer not work?
Make sure both fuses are intact and tight, or that either circuit breaker has not tripped. You can test the breaker by turning the breaker off and then back on. Replace the fuse(s) or reset the circuit breaker(s). If the problem continues, call an electrician.
How do you reset a Maytag Neptune dryer?
To reset the dryer if an error code occurs, press “Power/Cancel” twice and then reselect a cycle and press “Start.”
Why did my Maytag dryer stop drying?
Clogged dryer vents are probably the most common cause when your Maytag dryer takes too long. Even if you clean your dryer’s lint filter regularly, lint will still find its way to the vent system. When this happens, airflow will be restricted, and you’ll notice your dryer leaving clothes damp.
Do dryers have reset buttons?
Many dryers are equipped with a reset button on the control panel. If the motor won’t run, let the dryer cool for about ten minutes. Then push the reset button. If there are no problems with the motor, switches, or electrical system, this should restart the dryer.
Is there a fuse in a Maytag Neptune dryer?
Dryer thermal fuse. Located on the blower housing. If the dryer overheats, this high-limit thermostat will cut off the power to the heating element.
Why isn’t my dryer fully drying my clothes?
Check the Air Vent and Duct Clogged air vents are a common cause for poor airflow in clothes dryer systems. One way to see if your dryer’s air vent is clogged is by turning on your dryer and going outside to feel the flow of air leaving the vent. If it’s slow and not very warm, your vent may be due for a good cleaning.
How do I reset my Maytag Neptune washer?
How to Reset the Sequence for a Maytag MAH5500BWW
- Locate the “Off” button, located to the right of the Neptune’s “Start/Pause” button.
- Press the “Off” button within the first 30-seconds of beginning the cycle to cancel the current cycle.