What is extended access list?

What is extended access list?

What is an extended access list? Extended Access Control Lists (ACLs) act as the gatekeeper of your network. They either permit or deny traffic based on protocol, port number, source, destination, and time range. The range of customization is massive.

How do I make an access list in Asa?

They can be applied in- or outbound. There are a couple of things you should know about access-lists on the ASA: When you create an ACL statement for outbound traffic (higher to lower security level) then the source IP address is the real address of the host or network (not the NAT translated one).

What is extended ACL Cisco ASA?

Extended ACLs The majority of ACLs that will most likely be implemented on an ASA are using the extended ACL type. As with other platforms, the extended ACL is used to specify both source and destination and can include information about the specific protocol being matched.

What is an advantage of using a extended access control list?

The biggest advantage of an extended access control list is the ability to distinguish and filter packets based on source address, destination address, protocol and port number. This gives greater flexibility to the system administrator in designing the network.

What is difference between standard and extended access-list?

Standard Access lists match only based on the source IP address of the packet. Extended Access lists can match on source and destination address, in addition to port, protocol, and many other fields.

How do you use an extended access-list?

Extended access-list is generally applied close to the source but not always. In the Extended access list, packet filtering takes place on the basis of source IP address, destination IP address, port numbers. In an extended access list, particular services will be permitted or denied.

What is Access Group in Asa?

What is an Access-Group command? You use an access-group command to apply an access-list to an interface, in a particular direction (in or out). Although I always apply access-groups in an interface to avoid confusion.

What is access-list on ASA?

An ACL is a list of rules with permit or deny statements. Basically an Access Control List enforces the security policy on the network. The ACL (list of policy rules) is then applied to a firewall interface, either on the inbound or on the outbound traffic direction.

What is access-list in Cisco ASA?

Standard access lists identify the destination IP addresses of OSPF routes and can be used in a route map for OSPF redistribution. Standard access lists cannot be applied to interfaces to control traffic. All models Base License. Supported in single context mode only.

What’s the difference between standard and extended access-list?

Where should extended access lists go?

Extended ACLs should be located as close as possible to the source of the traffic to be filtered. This way, undesirable traffic is denied close to the source network, without crossing the network infrastructure. Standard ACLs should be located as close to the destination as possible.

How do you use an extended access list?

What is Access Group command?

Which of the following describes how an extended access control lists can improve network security?

Which of the following describes how access control lists can be used to improve network security? An access control list filters traffic based on the IP header information, such as source or destination IP address, protocol, or socket number.

What is ace in access-list?

An ACE is a single entry in an ACL that specifies a permit or deny rule (to forward or drop the packet) and is applied to a protocol, to a source and destination IP address or network, and, optionally, to the source and destination ports.