Why is my Atwood water heater not working?
One of the most common problems with Atwood RV water heater is a pilot outage. This can happen if you have a weak gas control magnet or if the thermocouple needs to be replaced. For poor pilot flame, you would need to replace the orifice. If it is not too old hen you can try cleaning the orifice and see how it goes.
Where is the reset button on an Atwood RV furnace?
Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
How do I know if my RV water heater element is bad?
Touch a probe on the multitester to each screw on the element. If you get no reading, or a maximum reading, the element is bad. Elements do have some resistance, so a reading of 10-16 ohms is normal, with higher ohm readings for 3,500 watt elements and lower readings for 5,500 watt elements.
Why is my Atwood gh6-6e water heater not heating up?
When this happens to the GH6-6E Atwood water heater then the source of the problem could be the regulator or the thermostat or both. The solution t this problem, if these are the source, is to replace them.
How do I troubleshoot an Atwood RV water heater?
Always refer to the Atwood RV water heater troubleshooting guide or manual you have from the manufacturer. Always call in a plumber, electrician or technician specializing in water heater repair if you think the problem and the remedy is beyond your deftness.
What size water heater do I need for my Atwood furnace?
The 8500 or 8900 models are the most compatible with your Atwood heater and should plug in easily. There will be the same 20-second delay that happens on your furnace when you power up the water heater.
How do I know if my Atwood heater board is bad?
The 8500 or 8900 models are the most compatible with your Atwood heater and should plug in easily. There will be the same 20-second delay that happens on your furnace when you power up the water heater. If nothing else is wrong, the heater should fire up and work like normal. This test should tell you if the original board is bad or not.