How do I reset my FS gt3b?
Power on the TX, then simultaneously turn the wheel right and press the BACK button. This will clear all model memories.
What is failsafe in RC?
The failsafe is connected in line between the receiver and the throttle servo. When a failsafe detects a loss of radio signal or low battery voltage, it will move the throttle servo to a pre-determined position, set by the modeler, usually full or partial braking, to stop the vehicle and prevent damage.
How do I set up failsafe?
Frsky
- Bind the receiver first and turn on both the transmitter and receiver;
- Move the controls to the desired failsafe position for all channels;
- Held down the F/S button of the receiver (for a second). The GREEN LED of the receiver will.
- To disable/reset the failsafe function, re-bind the receiver.
How do I troubleshoot a GTR 8000 base radio?
GTR 8000 Base Radio troubleshooting requires an understanding of hardware-based and software- based diagnostics, as well as testing tools. Support is available from Motorola Solutions to assist with all steps in the troubleshooting process. This chapter provides fault management and troubleshooting information relating to GTR 8000 Base Radio. 8.1
What are the external interfaces on the GTR 8000?
The transceiver external interfaces include seven external ports, a switch, and LEDs. If a transceiver option card is part of the transceiver, there are four additional external ports. See GTR 8000 Base Radio Front Connections on page 110 for the port connections. See GTR 8000 Base Radio LEDs on page 264 for information on the LEDs. 2.1.1.3.1.
What RF adapters are available for the Motorola GTR 8000 base radio?
The GTR 8000 Base Radio employs a number of “QN” and “QMA” Quick-Connect RF connectors in its design. The following RF adapters are available from Motorola Solutions and can be used to connect test equipment to the various station devices for troubleshooting purposes.