What does camming Harley do?
By installing a cam upgrade on your Harley, you can increase horsepower or torque by essentially changing your valve timing. You’ll be letting the exhaust out and fuel/air in at very specific times. By changing this timing, you can increase maximum torque in different ranges, such as low or high.
How many camshafts does a Harley have?
A unique feature of Harley-Davidson’s ‘Sportster’ engines since their introduction in 1957, is their use of four separate camshafts, all geared together.
Is a cam worth it Harley?
Installing aftermarket cam also helps in improving your bike’s torque. Many people agree that after installing aftermarket camshafts in your bikes, the torque production increases by 30% on an average. Therefore, after getting camshafts in your bikes, you can significantly improve its torque too.
How much HP does a cam add to a motorcycle?
While it’s true that camshaft adds horsepower, it’s only 10-20 horsepower and generally less than a 10% increase.
Do cams make a bike faster?
For an engine with a cam properly matched to the displacement and compression ratio, the net result will be more power at middle and higher engine speeds.
How long does it take to install a cam in a Harley Davidson?
If the dealer quoted for keeping solid push rods 8-10 hours is close. BUT there is no need to put solid push rods back in on a cam change, just cut the solids with a bolt cutter and install adjustable ones. 4-5 hours tops.
How much does a cam upgrade cost?
Assuming you provide your own new camshaft, most shops will charge between $600 and $1,000 to cam your truck. If you plan on doing the job yourself, make sure you set aside an entire weekend. Though it’s not terribly difficult, it can be very time-consuming.
What is a Stage Two upgrade for Harley Davidson?
The Stage 2 Harley-Davidson® upgrade involves a cam change. We can provide a stage 2 torque kit that gives you a significant improvement when you’re passing or accelerating by targeting lower RPM performance. Or, a stage 2 power kit upgrade increases your rev limit to 6400 RPM for increased mid-range horsepower.
Is it hard to change a camshaft?
Most shops will mark it off around 16 hours, if everything goes well. The most time-consuming part is pulling out the engine and putting it back in. Replacing the actual camshaft is pretty easy and quick.
Are aftermarket camshafts worth it?
With that said, aftermarket cams are designed for high-end performance, so you can typically expect to experience faster speeds after camming a truck. Are Bigger Cams More Powerful? Yes. A bigger cam will open the intake valve wider, allowing more fuel and air into the cylinder.