What is HPF setting?

What is HPF setting?

A high-pass filter (hpf) is an audio frequency filter that cuts (filters out) frequencies below a set level. For example, if you set a high-pass filter at 300hz, you’d lose a lot of the bass sound from instruments that have frequencies in that lower range.

What is a 10 db pad?

Technical Editor Hugh Robjohns replies: The 10dB (or sometimes 20dB) pad on capacitor mics is intended to prevent the head amplifier (the part of the mic which amplifies the signal picked up by the diaphragm) from overloading when the mic is placed in front of very loud sound sources.

What are HPF settings?

What Hz should I set my HPF to?

60 to 80 Hz high-pass. Works best with a subwoofer to complement them.

What is the best HPF setting?

Recommended Starting Points:

  • Front Component Speakers – High-Pass Filter = 80 Hz (12 db or 24 db Slope)
  • Rear Coaxial Speakers – High-Pass Filter = 80 Hz (12 db or 24 db Slope)
  • Subwoofer(s) – Low-Pass Filter = 80 Hz (12 db or 24 db Slope)

What is best Hz for subwoofer?

What is the recommended crossover frequency for a subwoofer? For THX Certified and non THX Certified home theater systems, 80 Hz is the recommended setting. However, you can set the crossover (LPF) between 80 Hz – 120 Hz based on which setting sounds best for your system.

What’s the best LPF setting?

As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speaker’s lowest frequency response. For example, your speaker’s frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofer’s low pass filter to 30Hz.

What is a 20dB pad?

a 20dB pad attenuates the incoming signal by 20db… This enables you to input extremely loud sources and close mic things which would otherwise cause distortion. It is a pretty good feature…not familiar with the unit or how you will use it.