What oil should I run in a 602 crate motor?
PTRO is a semi-sythetic Purpose Tuned Racing Oil designed specifically for your crate 602, 604 and 525 engines. This racing oil has an all in one lubrication protective and Racing package formula in it… Just pour it in and you’re done, it’s that easy.
How much oil does a 602 crate motor take?
8 quart
The 602 engine uses an 8 quart pan (including filter) that is 8” deep.
How do you check the oil on a 602 crate?
Recommended Oil Level for GM 602/604 Second, using the oil level inspection plug make sure that oil is near the recommended level. Third, warm the engine to near operating temperature. Finally, with the engine level, warmed up, and running at idle remove the oil inspection plug and measure the oil level.
How much horsepower does a 602 late model have?
The new stock ‘602 crate motor will usually make 365 to 375 horsepower. After our “Undercover Porting” cylinder head modifications & Crate Master camshaft, the same motor will typically dyno out at 410 to 420 horsepower. Torque also improves 15 to 30 ft. lbs.
What should the timing be set at on a 602 crate motor?
602/604 TIMING 1) We recommend that both these engines be set at a TOTAL timing of 32 degrees. NOTE: different amounts of timing may be beneficial due to different fuels, exhaust designs, carburetor choices and weather/altitude conditions.
How do you break in a 602 crate motor?
How Hard Is It To Break In A GM Crate Engine?
- Prime the engine with motor oil.
- Manually set the initial spark timing.
- Warm up the engine to 180 degrees Fahrenheit.
- Verify that you have the correct timing.
- Drive the engine at varying loads and conditions for the first 30 miles.
How do you check the oil in a 602 crate?
What makes a 602 crate motor?
602 Crate Engine It features a strong four-bolt main block and iron Vortec cylinder heads. A unique dual-pattern camshaft helps deliver more than 300 lb. -ft. of torque between 2,000 and 5,500 rpm peaking at 396 lb.
What are the parts of a GM ct350 sealed 602?
GM assembles the CT350 Sealed 602 with an 8-quart circle track racing oil pan, balancer, HEI distributor and an aluminum high-rise, dual-intake manifold. Add your carburetor, starter, spark plugs, wires and water pump as well as GM’s anti-tamper bolts to seal it up.
Where is the inspection plug on a 602 engine?
The inspection plug for the 602 is on the right side of the pan and both 604 and 602 inspection plugs are higher than the centerline of the pans. Do not confuse the inspection plug with the drain plug as they both have a 9/16 wrench head. Special Note: The engine will not break in properly without a load on the crankshaft.
What is the warranty on a Chevy performance crate engine?
Chevrolet Performance Crate Engines carry a 24 Month or 50,000 mile warranty (whichever comes first) when installed by a qualified independent service center. Chevrolet Performance Crate Engines also come with a 30 day start up warranty (parts only).
How much spark plug do I need for a 602 Pan?
On tracks with extremely long straight-aways 1 additional quart may be needed to maintain a safe level. The inspection plug for the 602 is on the right side of the pan and both 604 and 602 inspection plugs are higher than the centerline of the pans.