How do I fix BIOS not detecting hard drive?
Check if the hard drive is disabled in the BIOS
- Restart PC and enter system setup (BIOS) by pressing F2.
- Check and switch on hard drive detection in system configurations.
- Enable the auto-detection for future purpose.
- Reboot and check if the drive is detectable in BIOS.
Why is my computer not detecting my internal hard drive?
The BIOS will not detect a hard disk if the data cable is damaged or the connection is incorrect. Serial ATA cables, in particular, can sometimes fall out of their connection. Be sure to check your SATA cables are tightly connected to the SATA port connection.
How do I enable auto detection in BIOS?
Check for Auto Drive Detection
- When you switch on the PC, press F2 for entering into the System Setup or CMOS Setup.
- Go to BIOS setup page.
- Check if the hard disk drive detection is set to Auto or On.
- If it is not, then make it on.
- Press Save & Exit changes.
Where is SATA configuration in BIOS setup?
The user will need to check the “SATA Configuration” type in BIOS Setup Utility as shown below: Boot the system. Press F1 to enter into the BIOS Setup Utility. Choose the menu “Advanced -> SATA Configuration”.
Is BIOS on hard drive or motherboard?
From the Wikipedia Article on BIOS: BIOS software is stored on a non-volatile ROM chip on the motherboard. … In modern computer systems, the BIOS contents are stored on a flash memory chip so that the contents can be rewritten without removing the chip from the motherboard.
Where is SATA mode in BIOS?
The user will need to check the “SATA Configuration” type in BIOS Setup Utility as shown below:
- Boot the system.
- Press F1 to enter into the BIOS Setup Utility.
- Choose the menu “Advanced -> SATA Configuration”.
- Set “SATA#1 Configuration” to be “Enhanced”.
How do I change SATA mode to BIOS?
In the BIOS Setup utility, use the Right Arrow key to select the Storage tab. Use the Down Arrow key to select Storage Options, and then press Enter. Next to Sata Emulation, select the controller mode you want, and then press F10 to accept the change.