What percentage should TPS be at?
The TPS on a ETC (Drive by Wire) car should be ballpark 8-18% (it will depend on your setup, but these values would be a reasonable median value), so what your seeing sounds normal.
Do you have to calibrate a TPS?
Once you have fitted a Throttle Position Sensor, or TPS, you will need to calibrate it from within MEITE. First, be sure you have correctly wired, and assigned the throttle sensor signal input to “TPS Raw” in the Analog Settings.
How do I adjust the idle speed on my electronic throttle body?
Disconnect the idle air adjustment valve by locating and disengaging the electronic connector that holds it to the throttle body. Turn the idle screw to adjust the idle—turn the screw to the left to increase the RPM or to the right to lower it.
Do TPS need to be calibrated?
What voltage should a TPS read at idle?
When the throttle valve is in idle state or slightly open, the voltmeter should read voltage of 5.0V.
Can TPS cause misfire?
If you start to experience engine misfires, stalling, or rough idling when the car is stopped, it can also be a warning sign of a failing TPS.
How do I adjust the TPS on my car?
Use light pressure, as a small amount of movement on the TPS will result in a large change on the display. After adjusting the TPS, tighten the screws. Check to make sure the centre bar is still visible. Rev the engine slightly and allow it to idle. Adjust the TPS again if the centre bar is not visible. TPS adjustment above idle must be checked.
What rpm should the TPS be at idle?
The top adjustment bar should be visible at 1400 RPM. If the top bar does not become visible off idle, further adjustment of the TPS is needed. Adjust the TPS so the centre bar is visible at idle, but the top bar is visible at 1400 RPM.
How do I know if my TPS is off idle?
Another way to verify above idle adjustment is to use the fast idle, (choke), lever. Open the lever so the engine speed rises to 1400 RPM. The top adjustment bar should be visible at 1400 RPM. If the top bar does not become visible off idle, further adjustment of the TPS is needed.
What are the running characteristics of the TL1000S?
The TL1000S will have different running characteristics than four cylinder motorcycles, especially at lower engine speeds. When riding the TL1000S, the operator can feel the power pulses the engine produces from idle to 4000 RPM.