How do I lock my dbx 260?
How can I quickly lockout the front panel controls on the DriveRack 260? To lock out the front panel controls press and hold the WIZARD button upon power up (make sure all amplifiers are turned off before performing this procedure). When in the lockout mode, turn the ENCODER until the display reads “System Locked!”.
What does a dbx do?
Dbx noise reduction systems work in a way that is fundamentally different from the early Dolby systems. They use compression (to tape) and expansion (from tape) of the audio to lower the relative noise levels and effectively double the dynamic range.
What is the dbx DriveRack 260?
The dbx DriveRack 260 is the most effective way to manage all aspects of post mixer processing and signal routing. The DriveRack 260 essentially becomes the only device that you will need between the mixer and the power amps. The following are just some of the features of the DriveRack 260.
What is the DriveRack 260 complete equalization and loudspeaker management system?
INTRODUCTION Congratulations on your purchase of the dbx® DriveRack® 260 Complete Equalization and Loudspeaker Management System! For over 30 years, dbx has been the industry leader in dynamics processing. With the DriveRack 260, dbx Professional Products has redefined the standard by which all other loudspeaker management processors will be
Why choose dbx® DriveRack?
There is a reason that Tour Sound Professionals and discriminating Audio Contractors choose dbx® DriveRack® products for their high-end tours and installs. The DriveRack products provide the tools that ensure that the system sounds its very best. With the introduction of the new 260, the heritage of unrivaled system/loudspeaker control continues.
What does the power switch do on the DriveRack 260?
The Power Switch turns the DriveRack 260 on and off. Note: dbx Professional Products recommends that power amplifiers connected to the DriveRack 260, should be powered down prior to cycling the power on the DriveRack 260. PC Connection This DB-9 type connection is used to send and receive information to and from the GUI interface and for firmware