How do I login to my Tenda router?
Enter the address “192.168. 0.254” into the address bar in any browser, and enter the default Name & Password (admin & admin) to login the configuration interface. Scenario 2: If the W6-S obtain IP from Tenda router automatically, please login the settings interface as follows.
What is Tenda router login password?
The default username for your Tenda router is admin. The default password is admin.
Why can’t I log into my Tenda router?
Note: You may need to proceed with the next solution if you still cannot login. Find a Reset or RST button/hole on the side of the Tenda device and hold down it for about 10 seconds. During which time, you will find that all the indicators turn on or off and several of them will back off or on later.
How do I log into my Tenda router after resetting?
Method 1:
- Step 1: Open the browser and input plc.tendawifi.com in address bar to login setup page.
- Step 2: Choose “System”
- Step 3: Tap “Reset” button.
- Step 1: Find the Reset button on the side of the PLC.
- Step 2: Press the reset button for 8 seconds until all lights on and then off few seconds later.
How can I change my Tenda WiFi password?
Step 1: Login the homepage.
- Open a browser then type “192.168. 0.1” into the Address Bar, press Enter.
- Then the interface will turn into the homepage, tap “Wireless Settings”, change your SSID and password in this page, and tap “OK”.
- The notice window would be shown on the top.
How to set up a Tenda router via HP?
The following is an easy way to set up a Tenda router via HP. First, activate the Tenda router that will be used. Then you can connect the SSID or Wifi signal to your mobile phone device. You will be guided to the Tenda Router activation web.
How do I configure the internet connection type of the router?
When you use the router for the first time or after you reset the router, the router automatically detects your internet connection type. You are recommended to select the detected type and follow the instructions of the quick setup wizard to configure internet settings.
How do I login to my router on Windows 10?
Enter the IP 192.168.0.1 into your browser and pressing enter. Enter your router username. Enter your router password. Press Enter, or click the login button. If you get a login error, try finding the correct default login info for your router and try again.
How to check the LED lights on the router after connection?
Please check the LED lights on the router after connection. Make sure SYS light is blinking ,WLAN light is on or blinking ,one of LAN ports (12,3,4) is on，WAN light is on or blinking 1、open your web browser (IE, Firefox,Safari,etc) ,find the address bar, leave it blank and type 192.168.0.1 Press enter.