How do I fix my compression faucet?
Instructions
- Shut off the Water Supply. Look for a small shutoff valve (usually with a football-shaped handle) on the water line under the sink.
- Remove the Faucet Handle.
- Remove the Valve Stem Assembly and Cover (if present)
- Remove the Stem Washer.
- Find a Replacement for the Old Washer.
- Reassemble the Faucet.
How do you open a compression faucet?
Compression Faucet Use a screwdriver to remove the handle screw, then pull off the handle. Use a crescent wrench to unscrew the packing nut and an adjustable wrench to loosen the stem from the faucet body. Unscrew the rubber washer from the bottom end of the stem to remove and replace the seat washer.
What is a common failure part in a compression faucet?
Valve seats connect the faucet and the spout as part of the compression mechanism. Over time, water sediments accumulate, causing the valve seat area to corrode and cause a leaky faucet. This corrosion leads to leakage around the spout.
What is usually the cause of a leak in a compression faucet?
Worn Out Washers The friction between a washer between two parts causes the washers to get worn out, hence leading to a leak. Dripping caused by worn out washers can be fixed by replacing the washer. This type of leak is typically found in a compression faucet.
What does a compression faucet look like?
Compression faucets are also double-handle, which means the hot and cold water lines are controlled through their own handle to the side of the water spout. However, a compression faucet is usually pretty distinguishable in that they feel less pressurized as they turn on, and more pressurized as they close.
What is a compression valve faucet?
1. Compression Valve. As the oldest type of faucet valve in use, compression valves are both simple and inexpensive. A compression valve consists of a screw stem that raises and lowers as it is turned and a rubber compression washer at the bottom of the stem.
How do I know if I have a compression faucet?
However, you can tell the difference by how the handles feel when used. A compression faucet requires you to tighten down (compress) the washer to close the water flow. With a cartridge faucet, the action is smooth and consistent. With a half-turn, the handle goes from the off to the on position.
Do I have a compression or cartridge faucet?
How to fix a compression faucet?
How to repair a compression faucet: Most leaky compression faucets need new seat washers. Use a screwdriver to remove the handle screw, then pull off the handle. Use a crescent wrench to unscrew the packing nut and an adjustable wrench to loosen the stem from the faucet body.
How to fix faucet problems?
Broken seal A thread-sealing tape is placed on all water connectors but may wear out over time causing leakages. The solution to this is to replace it.
How to repair a dripping outdoor faucet?
Turn the water off to the faucet.
How do you repair a kitchen faucet?
Locate the leak. Before you begin,inspect the faucet to figure out where the leak is.