Table of Contents
How do I fix the atomizer on my Voopoo vape?
How to Fix Check Atomizer/No Atomizer with a Vape Tank
- Try Another Tank/Mod.
- Clean Your Contact Points.
- Check the 510 Pin on your Tank. If the 510 pin on your tank is damaged (where it connects to the mod) then this will cause a “Check Atomizer” or “No Atomizer” error.
- Check the 510 Connector on your Mod.
- Reseat Your Coil.
How do you clean a Voopoo atomizer?
In that case, you can follow these steps for deeper cleaning.
- Remove wicks from coils.
- Dry burn your coils lightly (don’t let them glow too much)
- Remove atomizer from your mod.
- Place under running water.
- Brush them lightly with a toothbrush or a coil cleaning tool.
- Rinse once again.
Why does it feel like my vape is clogged?
The most common cause of a clogged cart is condensation buildup inside the cart’s airway. Over time, this condensation can block the mouthpiece, preventing vapor from passing through as you take a hit. Instead of a tasty hit of delta 8 THC, you get a clogged mouthpiece and a mouth full of bitter vape juice.
Why does my SMOK vape leak?
Putting too much e-liquid into your tank or pod can cause it to leak. Too much e-liquid can cause the coil to become flooded or for e-liquid to leak past seals when replacing the cap. Many tanks have recommended fill levels to prevent leakage and other problems caused by overfilling.
Why is my Voopoo vape leaking?
A) Over Filling: Overfilling your tank is the most likely reason for it to leak. Be sure to never fill your tank beyond the max capacity of the tank as it will leak out the top when you replace your coil. When in doubt, fill your device to about 90% capacity.
How do I reset my drag 3?
The puff counter data can be reset by holding the power/fire button and the down/- buttons simultaneously. The Drag 3 runs on Voopoo’s Gene Fan 2.0 chip and fires up to 177Watts. There are 2 main modes that can be changed by fast clicking the fire/power button 3 times.
What causes atomizer short?
Coils may have a short Also, some people may misjudge the size of their builds, causing their coil to touch the chamber and short out—and that will cause an “atomizer short” or an “atomizer low” error. Remedy: For factory coils, first make sure your coil is properly seated. If it still doesn’t work, try another coil.
What is dry burning a coil?
What is “Dry Burning” a Coil? “Dry burning” is similar to pulsing a coil, only this time after the wire has been put to use. Vapourising e-liquid will, after a time, cause the coil and wicking material to “gunk up” with matter that can affect the taste and performance given from your atomiser.