How far can you span C purlins?
Normally a spacing of C purlin is around 900mm (0.9m), 1200mm (1.2m) and 1500mm (1.5m). This can be spaced 1.2 metres apart when using sheeting with a thickness of 0.7mm, and 1 metre when using 0.5mm sheeting.
How far can metal purlins span?
A four-inch purlin can span 12 feet. A six-inch purlin can span 18 feet. An eight-inch purlin can span 25 feet. A ten-inch purlin can span 30 feet.
How far apart do you put purlins?
The maximum distance between purlins is five (5) feet on center. If your building site is in a region that is prone to heavy snow loads or high winds, then we may place your purlins closer together for added strength.
How much weight can 4 C channels hold?
| Type and Size | Member | Allowable Concentrated Load ( lbs ) At Center Of Span ( ft. ) |
|---|---|---|
| Single Angle | 5″ x 3″ x 3/8″ | 2100 |
| Single Angle | 6″ x 4″ x 3/8″ | 3140 |
| Single Channel | 4″ @ 5.4 # | 1510 |
| Single Channel | 5″ @ 6.7 # | 2290 |
Can C purlins be lapped?
PURLIN SIZES AND PROPERTIES Purlins without pre-punched holes may also be available by contacting Steeline. C sections have equally sized top and bottom flanges and are suitable for simply supported spans and continuous spans. Continuous spans have less deflection than single spans. C sections cannot be lapped.
Where can I buy a purlin load table?
WHIRLWIND BUILDING COMPONENTS 8234 Hansen Rd. | Houston, TX 77075 | (Phone) 713.946.7140 | (US Wats) 800.324.9992 Purlin Load TablesCombined Shear & Bending
What is the maximum roof slope for purlin load tables?
Purlin load tables are valid up to and including 25° roof slopes. For slopes greater than 25 °, use our MetSPEC design software. You can download our MetSPEC 14 software from the list below. Download our purlin technical manual for more information.
Where can I find limit state capacity tables for purlin configurations?
Limit State Capacity tables for different purlin configurations can be found in the user manual. NOTE: New South Wales designers must refer to the New South Wales LYSAGHT SupaZed® and LYSAGHT SupaCee® Purlins and Girts Range.
What sizes do you manufacture steel subgirts and roof purlins?
We manufacture any component from 1/2″ steel subgirts to 12″ section up to 10 gauge. Steel c-purlins and c-girts are also available with other depths and flange widths. Contact Flexospan for information on purlin and girt structural steel dimensions. Steel wall girts and roof purlins are manufactured and sold onsite.