What is a load box guitar?
Essentially, a load box is a device that acts as an interface in which the energy generated by a tube amplifier can be expressed, without using a speaker cabinet. An amp head creates a lot of energy and power, and there needs to be a location for that energy to go. The device “loads” the amplifier.
What is a load box used for?
Typically, load boxes are used to create a line- or mic-level signal that can then be sent to a preamp or mixer for recording or live sound amplification without need for a mic or unnecessary volume.
What is the purpose of dummy load?
A dummy load is a device used to simulate an electrical load, usually for testing purposes. In radio a dummy antenna is connected to the output of a radio transmitter and electrically simulates an antenna, to allow the transmitter to be adjusted and tested without radiating radio waves.
What is a reactive load?
Definition of reactive load : a load which is carried by an alternating current generating station or system in which the current and voltage are out of phase and which is measured in volt-amperes or kilovolt-amperes.
Why you need a reamp box?
A reamp box converts a low impedance, balanced line level signal to high impedance, unbalanced instrument level signal. The goal of the reamp box is to make the amplifier react in exactly the same way a live guitar would, but with a pre-recorded audio source.
How do you reamp a guitar without a reamp box?
You can reamp without a proper reamp box by using a di box backwards, or even just plug the line out signal (at low volume) directly into the guitar input of the amp.
Why active load is used?
In the area of electronic test equipment, an active load is used for automatic testing of power supplies and other sources of electrical power to ensure that their output voltage and current are within their specifications over a range of load conditions, from no load to maximum load.
What are examples of reactive loads?
A reactive/inductive load converts current into a magnetic field. It resists the change to voltage, causing the circuit current to lead voltage. Examples of devices producing reactive/inductive loads include motors, transformers and chokes.
Can you use a resistor as a dummy load?
Dummy loads for amplifiers can range from a single power resistor up to an array of resistors or even a benchtop electronic load. The dummy loads can be as simple or as complex as the user wants to make them.
What is a load box for a guitar amp?
This is where load boxes come in: They safely load your guitar amp and allow you to use it in numerous ways with no speakers. Examples of load boxes include the Suhr Reactive Load, Koch Dummybox Studio/PA, and the Two Notes Torpedo Live.
What is a load box and how does it work?
This is where load boxes come in: They safely load your guitar amp and allow you to use it in numerous ways with no speakers. Examples of load boxes include the Suhr Reactive Load, Koch Dummybox Studio/PA, and the Two Notes Torpedo Live. Think of a load box as the most basic form of attenuator, one that lowers your amp’s output to line level.
How do I use the X-Load LB-2 with my amp?
When no speaker is connected, the LB-2 safely loads your amp as though it were connected to a speaker cab. The X-LOAD LB-2 can be also be used to partially reduce the volume of your amp by diverting half of its power to the load. Connect one 4-ohm output of your amp to an 8 ohm speaker.
What is an attenuator load box?
Think of a load box as the most basic form of attenuator, one that lowers your amp’s output to line level. A load box can also send the loaded-down line-level amp signal to a second power amp, giving you total control over your tone and volume.